Vir2-instruments Acou6tics Manual Uživatelský manuál stáhnout pdf (Strana 28)

acou6tics

Acou6tics/Advanced Setup

PITCHBEND & VIBRATO

SETUP

Acou6tics/Advanced Setup

STRUMMING SETUP

CHAPTER 13/ PITCHBEND &

VIBRATO SETUP

CHAPTER 14/ STRUMMING SETUP

Pitchbend | Range:

Change the pitch bend range here.

Vibrato | Mode:

Change the vibrato mode here.

• All Strings

• Last String | Note: Only works with chord detection = 0ms

• Highest String | Note: Only works with chord detection = 0ms

• Lowest String | Note: Only works with chord detection = 0ms

Vibrato | Curve:

Change the vibrato curve here.

Vibrato | Max:

Change the maximum strange (?) of the vibrato here.

Vibrato Speed | Min/Max:

Set up the minimum and maximum rate of the vibrato here.

Vibrato | Type:

There are 2 options for vibrato type: ‘Up’ and ‘Up & Down’. On a real guitar

you can only bend upwards, not downwards. So the default setting here is

‘Up’, which means that the vibrato is always slightly sharp compared to

traditional LFO vibrato.

Strum | Default:

Set up the default strum type for chords played on the keyboard here.

Strum Time | Auto Adjust:

Strum time in Acou6tics means the time dierence between one string and

the next in a strum. If ‘Strum Time’ is set to 10ms, a strum over all six strings

for example will take 60ms. ‘Auto Adjust’ will automatically vary this strum

time. If a six string strum takes 60ms, a four string strum will also take

60ms, because the engine automatically compensates the strum time when

playing a four string strum. You can also set up the amount of ‘Auto Adjust’

here. 100% means full adjustment, 10% for example, means that a four string

strum will only be slightly slower than a six string strum.

DOWN-STROKE | UP-STROKE

Strum Speed | Start:

Set up the strum speed at the beginning of a strum here. If you set it to

110% and you have a strum time of 100ms, the strum speed at the beginning

of the strum will be 110ms. The ‘Strum Speed | Start’ and ‘Strum Speed |

End’ settings will allow you to accelerate or slow down a strum over time.

Strum Speed | End:

Set up the strum speed at the end of a strum here. If you set it to 90% and

you have a strum time of 100ms, the strum speed at the end of the strum

will be 90ms. The ‘Strum Speed | Start’ and ‘Strum Speed | End’ settings

will allow you to accelerate or slow down a strum over time.

CHAPTER 13 CHAPTER 14

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 38 39

Komentáře k této Příručce

Žádné komentáře

Vir2-instruments Acou6tics Manual Uživatelský manuál Strana 28

Komentáře k této Příručce

Související produkty a manuály pro Hudební nástroje Vir2-instruments Acou6tics Manual